Kundenbewertungen zu PEI - Dauerdruckplatte - Aluminium-Guss - feinstgefraest - natur
Anzahl der Bewertungen: 8
Durchschnittliche Bewertung: 3,9
Doesn't work after little use.
von Keith Mr am 20.07.2019
I bought this back in December 2018. I installed it with an AC heater on my CR-10s so it could reach higher temperatures and heat faster and more efficiently. I've not used it much but after printing with ABS a hand full of times the surface becomes smooth, so smooth that filament won't adhere to the bed for the initial layer. I've sanded it, used high/lower temps, flashed my firmware to allow the bed to heat to 135C and nothing works. It's useless. I went back to using a PEI glass sheet which works. I can feel a clear difference in the corners where nothing has printed.
If you can give me a resolution to this issue I'll change my rating.
von Anonymus am 11.06.2019
Flat and no sign from bending during the prints. I have made several long time prints and the flatness remain the same.
These are my temperature settings for first layer and the remaining layers: PLA 75/60, PETG 105/80 and ABS 135/105 degrees.
von Anonymus am 19.06.2018
Just tested it today in my new Hypercube Evolution build.
Is very flat even with only 3 supports.